Safety & Use Information (GPSR)

Product & Intended Use

Product: Bicycle double panniers / single pannier
Intended user: Adult cyclists
Intended use: Carrying everyday items on a rear bicycle pannier rack during normal road and cycle-path riding.

These panniers are not designed for extreme use, off-road riding, stunts or heavy industrial/cargo transport.

Key Safety Warnings

WARNING – No passengers

Do not carry children, pets or any passengers in or on the panniers. Serious injury may occur.

WARNING – Max. 5 kg per side

Do not exceed 5 kg per pannier side. Also check and follow your rack manufacturer’s maximum load rating.
Overloading may cause loss of control or rack failure.

WARNING – Straps must be fully closed

Always close and tighten all buckles and hook-and-loop (Velcro) straps securely.
Loose straps can catch in the wheel or brake and cause an accident.

WARNING – Keep clear of wheel and brake

Check that the panniers cannot touch the tyre, spokes or brake rotor at any point, even when loaded or when riding over bumps.

CAUTION – Balance the load

Distribute weight evenly between the left and right sides.
Place heavier items low down and close to the rack to maintain stable handling.

CAUTION – Visibility

Ensure the panniers do not block your rear light, reflector or wheel-mounted reflectors required in your region.
Fit an additional light/reflector if necessary.

Fitting & Rack Requirements

Fitting

The panniers attach to the rear rack using:
• Two strap buckles on the top
• Two hook-and-loop straps on the bottom

Make sure all straps are routed correctly around the rack tubing and tightened before every ride.

Rack requirements

Your rear rack must be:
• Suitable for panniers
• Rigidly attached to the bicycle frame
• Ideally equipped with three side support legs to prevent the bags interiring with the spokes
• A platform width of 12–16 cm (4.7"–6.3") is recommended

Do not use seatpost-only racks or any rack that cannot safely support the total load.

Before installation, ensure your rack is in good condition and compatible with panniers.

Safe Use & Maintenance

Before each ride

• Check all straps, buckles and fasteners are securely closed.
• Ensure the bags cannot move into the wheel, tyre or brake when the bicycle is pushed or bounced.
• Confirm all closures (zips, roll-tops, flaps) are properly closed to prevent items from falling out.

During use

• Ride according to conditions – extra weight affects braking distance and handling.
• Avoid placing sharp edges or heavy point loads directly against the fabric.
• Do not place hot, flammable, corrosive or leaking substances inside the panniers.

Inspection & maintenance

• Regularly check stitching, fabric, hooks and straps for wear or damage.
• Stop using the panniers immediately if you notice tears, broken stitching, damaged buckles or rack deformation.
• Clean using mild soap and water only.
Do not use solvents, bleach or high-pressure washers.

Storage & Environmental Information

Storage

Store the panniers in a cool, dry place away from direct sunlight and heat sources.

Disposal

Dispose of the product according to local regulations.
Where possible, separate metal and textile components for recycling.

Manufacturer Information

Manufacturer: Emk Commerce Ltd
Website: bikybag.com
Support: contact@bikybag.com